You're new here! Welcome, please feel free to browse our store.

Gas engine CDI Ignition Test and Timing Set up Tool - Includes Crankshaft Degree Wheel

Gas engine CDI Ignition Test and Timing Set up Tool - Includes Crankshaft Degree Wheel
Our Price: 14.56
Quantity:

Gas engine CDI Ignition Test and Timing Set up Tool - Includes Crankshaft Degree Wheel

This is a fantastic tool for those of us using gas powered engines in our models!Anyone who uses Gas powered CDI ignition engines should have this tool.

This tester can be used in two ways:

1. It enables the safest possible way to check for interference between your CDI Ignition and radio systems, without the need to have your engine running. The unit fires your ignition system at the rpm you set on the units dial to simulate the ignition as if the motor is running, the units RPM range is 400-18000Rpm.

2. The unit can also be used to set up a Gas engines static base timing, included is a crankshaft degree wheel to assist with this task. In this mode the test unit emits a beep at the point where the the ignition sensor (Hall sensor) is interrupted and using the degree wheel you can calculate this back to degrees before top dead centre (BTDC) of your engines piston stroke, allowing you to fine tune your engine for maximum performance.

Take the guess work out of your Gas engines ignition timing and add safety to RF interference testing!


Customer Reviews

There are currently no reviews for this product. Be the first to review by clicking below!


Review this product...

People who purchased this also purchased...

All Metal Servoless 90 Degree Retract for Large Models (10~12kg) with 10mm Pin - PZ-15096B
Our Price: 41.99

Futaba/JR Servo Extention Lead Connector Caps
Our Price: 1.78

15CM Servo Lead Extention (JR) with hook 26AWG
Our Price: 0.69

TURNIGY Smart Retractable Landing Gear and Door Sequencer
Our Price: 9.99

New Product
25mm Blenderm Tape - 1 Roll 4.5 meters
Our Price: 8.49