You're new here! Welcome, please feel free to browse our store.

FRS Failover Regulator Switch 5A-Plus

FRS Failover Regulator Switch 5A-Plus
Our Price: 29.99
Quantity:

Description

 

FRS Failover Regulator Switch 5A-Plus

This Regulator switch is an easy and convenient way to add dual power redundancy to your electronics system. Simply use a pair of 7.4v Lipoly batteries and the system will provide dual 5.9v power outputs. The dual outputs can be used for 2 receivers or with a single receiver by using only one power output. In the case of a single output/single receiver configuration the output being used is supplied power by both batteries or a single battery in the case of a battery failure.





This system provides a stabilized voltage of 5.9v. Perfect for 6v Rx systems. This design enables you to use the latest lightweight Lithium-Polymer cells without exceeding the maximum voltage of 6.0 Volts.

 

The Sensor is equipped with LED power-on indicators for both power circuits. If you switch one battery on, the associated green LED glows. When both batteries are active, both LEDs light up.

The total voltage loss in the Sensor is about .35v which is so low that the volume of waste heat is almost negligible. The maximum continuous current is 5A which means it can easily handle up to 8 servos. However the rated continuous current of 5A does not reflect the capacity of the electronics which can handle much more for short periods, depending on ambient air temperature.

SPECIAL NOTE ON USE:-

As the voltage is stabilized at 5.9V, it may be used for the ignition of a gas engine that needs no more than 6V critically  It is commonly known that some of them do NOT like more than 6V, and if a backup battery for ignition is needed this can be the answer

If you do use it for ignition do not use it for you radio as well.. you must have a totally separate system for ignition .
If you do use for the radio and ignition then you will create a common ground between your ignition and your radio ... bingo spark interference straight into your radio.

Do not allow the heat sink to exceed 60 Celsius


Specs:
Operating Voltage: 4~9v 
Power Supply: One or Two 2S 7.4v Lipoly
Max Load: 5A cont.
Voltage Loss: 0.35v
Voltage stabilization: +/- .1v
Weight: 35g

Directions.
You cannot manually switch the current from one battery to the other, this is done automatically within the system.
The control functions consist of three push-buttons, two green LED?s and one red LED.
The buttons are marked SET, I and II.
The ?SET? button is to prepare the system. Holding the SET button in for 2 seconds ?arms? both internal switches, this will be shown by the red LED. After you have armed the system, press either or both I, II buttons to activate each battery.
Press and hold ?SET? to switch the system off again.

Customer Reviews

There are currently no reviews for this product. Be the first to review by clicking below!


Review this product...